Tape the two pieces together.Īs I mentioned earlier, you will do this once if you don’t care that your artwork folds outward. Glue down the first piece, lining up the edges as best as you can. Place glue on most of the area except by the joint. Glue the First Two Piecesĭepending on whether you want your board to fold with the artwork out (unusual) or inward (common) you will either have to do one or two of these procedures respectively. You can see an example of the cut photo paper above in the image with the glue stick. Once they are printed I will cut off the white margins for all the interior edges that will join up together. When you print this way you will print on several sheets of paper. Publisher will require you make a larger template, but that is pretty easy to do. When I work with larger sized images I usually print them from either MS Publisher or MS Powerpoint. If you have the artwork ready, then here are the steps I follow to make my quad fold boards… Print the Artwork My assumption here is that you already have artwork you’ve created. If I could cut through two matte board pieces at a time then I would probably use a different method. The methods in this article are based on the fact that I have a 12 inch rotary cutter that cannot cut through two pieces of matte board at the same time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |